Conduit, cable tray, wire pulling and termination, device mounting, panel wiring, and grounding, self-performed under our Texas Electrical Contractor License (TECL# 41990). Built right the first time so loop checks don't find what the inspector missed.
15+
Years Field Experience
0.0
TRIR Safety Record
Class I
Div 1 & 2 Rated
24hr
Typical Response Time
What We Install
Installation Scope
Conduit & Cable Tray
Rigid, IMC, and flexible conduit runs; ladder, trough, and wireway systems to spec
RGS, IMC, EMT, and LFMC conduit systems including hazardous location sealing fittings (Class I, Div 1 & 2)
Ladder, trough, solid-bottom, and wireway cable tray with penetration seals and expansion fittings
Conduit supports, hangers, and unistrut to project and NEC requirements
Bluebeam as-built redlines updated as conduit is installed — no reverse-engineering at turnover
Cable Pulling & Termination
Power, control, instrument, and fiber — pulled, dressed, and terminated to spec
600V power, control, MC cable, SER, and armored SHD cable pulls
Instrumentation: thermocouple, RTD, 4–20mA signal cable, and data highway
Fiber optic installation, splicing, and termination
Torque-controlled terminations with heat-shrink and wire markers per loop drawing
Point-to-point verification documentation included at no additional cost
Panel & MCC Wiring
Control panels, junction boxes, MCCs, marshalling cabinets, and local control stations
Control panels, marshalling cabinets, junction boxes, and local control stations (LCS)
Motor Control Center (MCC) bucket wiring and terminal block terminations
DIN rail component mounting, wire duct routing, and labeling per project standard
PLC/DCS I/O terminations verified against loop drawings before sign-off
Instrument Device Mounting
Transmitters, switches, analyzers, valves, and actuators — per P&ID and instrument index
Pressure, DP, temperature, flow, and level transmitters; gas detectors and flame scanners
Control valves, actuators, solenoids, and local gauge assemblies
1/4" and 1/2" SS and CS impulse tubing with block, bleed, and bypass valve assemblies
Analyzer sample systems, sample conditioners, and probe installations
Installation documented against P&ID, instrument index, and data sheet — every device
Grounding & Bonding
Ground grid connections, equipment bonding, static discharge points, and test points per NEC
Equipment grounding conductors to ground grid with listed lugs and hardware
Static bonding cables and clamps for flammable and combustible liquid service
Intrinsically safe (IS) ground bars, zener barriers, and IS circuit segregation
Ground electrode resistance testing and documentation per NEC Article 250 and NFPA 70E
Pre-Commissioning Checks
Continuity, insulation resistance, and point-to-point verification before loop checks begin
Megger (IR) testing on all power and control cables before energization
Continuity verification of every wire run against loop drawings
Panel energization checklist with supervision sign-off
Punch item identification documented in Bluebeam punchlist format
Pre-commissioning turnover package prepared and ready for loop check hand-off
Why Rogue for Installation
Built to Commission
We install with commissioning in mind. Terminations labeled right, conduit seals placed correctly, documents current. Loop checks don't find what the install crew rushed.
Class I, Division 1 & 2
Hazardous location work on natural gas compression, processing, and LNG facilities — the environment we know from the ground up.
Design Review Before First Conduit Run
We offer pre-construction P&ID and loop drawing review so field fit issues are resolved before they become schedule problems.
Bluebeam As-Built from Day One
Redlines in Bluebeam as the work happens. No reverse-engineering field notes the week before turnover.
Ready to Discuss Your Installation Scope?
Licensed Texas Electrical Contractor, TECL# 41990. One business day response.